The Potential Application of HHO Technology into Diesel Generators
About Author
Melvin Lee is one of the team of Hydrox Innovation that recognises the problem posed by the ever depleting fossil fuel supply and through dedicated research and innovative development. Copyright A 2009 Melvin Lee http://www.water4gasinstaller.com
Can I make a wind turbine using a gas generator?
I have access to a small gas-powered generator that can run a few appliances. It doesn’t run anymore, so I was wondering if I could put windmill blades on it. If it is possible to do it, could i plug it right into an outlet and feed power into our system? I know it can’t run the whole house, but it could reduce our elec. bill right?
how much liter of fuel required in hour to produce 50 mw in gas turbine generator?
fuel consumption of gas turbine generator in liter to produce 1kwh
what is the weight of gas turbine generator parts?
How much a turbine generator weighs in parts as below
turbine
alternator
exciter
the gasturbine generator model is westinghouse W501D , 143.33MW
Gas Turbine Generator load is 4 mw & cap. is 5 mw what’s the probability of trip if i further start 1mw motor
If i start motor of 1 mw it takes initial amps 7-8 times higher than rated for 2-3 sec. It is safe to run the same. or any chances to trip the Gas turbine Generator? If there then what & Why?
Mr Tippy is right about the speed issue but you can overcome this by getting an inverter. Most wind turbines run at variable speeds so they use an inverter to convert the “wild ac” current to a usable form normally 240 volt for home systems. These inverters come in many different sizes to match your generator and can be purchased from many of the online green energy supply places. Sunny boy is a popular brand.
You will also need to figure out how big the blades need to be for your size generator. My wind turbine is 20kw and has a 31 foot diameter blade span. This is huge for a home system and I often get a check from the power company. So you will probably need to research the proper blade size.
One concern that I would have is the bearings in the generator, are they heavy enough to handle the weight and stress of the blades.
what is the price of GE gas turbine generator model (MS900 1FA 50Hz) USA and Mitsubishi (M501 G) from Japan?
what is the price of GE gas turbine generator model ( MS 900 1FA 50Hz) (255.6MW) from USA and Mitsubishi gas turbine generator model( M 501G) (254MW) from Japan?
both brand new.
Looks like you are on the edge in this case. Even if you did manage it you are then running at 100%.Relay protection will not allow this for many reasons.
The motor would need to be started with the help of reduced start current ie star delta starter.which is not the case from what you mention above You could also raise the voltage of the main transformer via tap changer if applicable, to assist in lowering the start current.
Best option reduce the present load of all non essential loads as possible.
GE gas turbines around 2-5 million dollar. depending on if they are new, used or rebuilt. I believe that the Japan tubines are a little less, 1.5- 4 million. I worked for a power plant.
Not enough data at all , whats the efficiency of that generator , whats its specifications , output range…..etc.